Today's wedding card is really 3D and it would need to have a box made for it to go in.
To make this card I started with a base of Whisper White with a layer of Tip Top Taupe (TTT) and a top layer of Whisper White.
I adhered the top two layers together, using Tombow and tied a piece of the TTT 1" Dotted Lace Trim around it. I moved it down towards the bottom and left a quarter inch gap. Then I adhered this to the card base using Tombow.
I stamped three of the large outline flowers from the Bloomin' Love Stamp set onto TTT Cardstock using TTT Ink and then I stamped three of the small outline flowers onto Whisper White Cardstock also using TTT Ink.
I die cut the six flowers using the Bloomin' Heart Thinlits Dies and also one of the heart using TTT Cardstock. As these are very intricate dies, I used my Sizzix Die Brush to remove all the bits from the die.
At the moment, the stamp set and dies are available in the current Spring catalogue as a bundle - this means you save 15% of the price if you were to buy the products separately.
I painted all over the heart and the 2015-2017 In-Colour Blossom Accents using my Clear Wink of Stella Glitter Pen. Then I used my Two-way Glue Pen to paint the back of the heart and then adhere it to my card base.
I layered one large and one small flower together using Tombow and adhered to the card using Dimensionals, and added a large pearl to the centre of each. Again, using Tombow, I adhered the Blossom Accents to the hearts.
I used small Glue Dots which I rolled into small balls and attached one large pearl to each of these.
There were eight tiny holes spread over the heart, so I put one tiny pearl on each of these!
For the sentiment, I chose Wedding Wishes which is from the Rose Wonder Stamp Set.
Using TTT Ink, I stamped the sentiment onto a piece of Whisper White Cardstock and very quickly dunked it into my plastic box of Clear Embossing Powder. I then heat set using my Heat Tool.
I punched the sentiment out using the Extra Large Oval Punch and layered it onto a piece of TTT Cardstock that I'd punch out using the Scallop Oval Punch. I attached it to the card using Dimensionals.
That's about it for today, so until tomorrow, happy crafting.